Hyper-V Flash Boot Job Wizard: Destination

On the Destination page, select a destination for the recovered VMs.

Note

• Due to Microsoft iSCSI Target Server limits on Windows Server, only 256 iSCSI target instances (VM disks) can be flash-booted per iSCSI Target Server.
  

Proceed as described in the sections below.

• Setting the Same Container, Path, and Network for All VMs

• Setting Different Options for Recovered VMs

Setting the Same Container, Path, and Network for All VMs

To run all VMs on the same container and path, and to connect all recovered VMs to the same network, choose a target container, path, and network from the appropriate drop-down lists.

Note
If you choose the Connect to temporary isolated network option from the Network drop-down list, NAKIVO Backup & Replication will create a new Hyper-V virtual switch and a new network on all hosts where VMs will be recovered. Recovered VMs will be connected to the newly created network.

Setting Different Options for Recovered VMs

To specify different options for VMs, follow the steps below:

1. Click Advanced setup.

2. Choose a target container and network adapter for each individual VM.

3. Click Next.

   
   

Note
If you choose the Connect to temporary isolated network option for a NIC, NAKIVO Backup & Replication will create a new Hyper-V virtual switch and a new network on the host where the VM will be recovered. The recovered VM will be connected to the network.