Configuring Network Settings of Virtual Appliance

To configure networking on the Virtual Appliance (VA), follow the steps below:

1. Open the VA console.

2. On the main menu, select the Network Settings option and press Enter.

3. Do either of the following:

   • To change the Virtual Appliance hostname, select the Hostname option, press Enter, enter a new hostname, and press Enter again.

   • To configure a network card, select it and press Enter. Press Enter to switch between DHCP and manual network settings. If you set the DHCP option to disabled, you can manually set up network settings by selecting an option, pressing Enter, entering a new value, and pressing Enter again. Press F10 to save your changes and exit.